NMRV025 reducer

MRV025 reducer

NMRV025 reducer production process: NMRV025 body, die-cast aluminum alloy; worm shaft, 20 Crq steel, high temperature treatment; worm gear, nickel bronze alloy; aluminum alloy body, sandblasted and surface treated with anti-corrosion treatment; cast iron body, using bIu RA5010 paint.

NMRV025 reducer working conditions: the use environment of NMRV reducer is lower than -30℃ or higher than 60-30℃, oil seal of special material must be replaced; the motor matched with NMRV reducer must be suitable for working in low temperature environment, and the power of the motor It is necessary to meet the torque requirements when starting at low temperature; the viscosity of the lubricating oil will be higher before it is ready to be put into use, and the machine should be loaded after a test run without load to avoid equipment failure; when using an NMRV reducer, run it at 150 -Change the lubricating oil after 400 hours, and the subsequent oil change reducer cycle is less than or equal to 4000 hours; regularly check the quantity and quality of the oil, reserve enough lubricating oil, and replace the oil mixed with impurities or deteriorated in time. The operating coefficient of the NMRV25 reducer depends on the actual operating environment. When selecting the appropriate service coefficient, factors such as the nature of the load at the output end, the operating time per day, and the frequency of start-up must be considered.