The cycloid reducer is suitable for a 24-minute time interval and allows two poles to travel.The strengthening of the output shaft of a single-stage cycloid reducer is related to the weakening of the output shaft, and the strengthening of the output shaft of a double-stage cycloid reducer is similar to the weakening of the output shaft.The input shaft of the cycloid reducer must never bear axial force.In public places where the exaggeration effect may be used, overload protection devices should be installed.The foot-type horizontal cycloid reducer should be installed on a very stable level foundation without oscillation, and in public places where it is necessary to install it at an inclined angle, the inclination of the speed up the axis of the machine must not be greater than ±15.When the flange-mounted vertical cycloid accelerator is installed, the output shaft goes vertically downwards.
XNUMX. If the cycloid reducer is connected to the wheel and sprocket, the parallelism of the axis of the two must be ensured.
If you need to use other specific installation methods other than foot-plate horizontal mounting and flange-type vertical mounting, appropriate lubricants and sealing measures must be implemented to ensure that the machine is lubricated and sufficient to prevent oil leakage.
XNUMX. If gears are used to connect the cycloid reducer to the motors of the mutual equipment, rigid gears are recommended.
When the cycloid accelerator is installed, the pad can be used for modification. The pad is never more than three in the highest peak path, and the wedge can also be changed. However, the flat pad must be replaced after the cycloid acceleration machine is calibrated.
XNUMX. In public places where the impact, vibration, or braking is severe, the base and the foundation are not only connected with foot screws, but also need to be specified with guide pins (loading).
衍生型摆线减速机的输入轴和输出轴的轴伸方式当作椭圆形，采用通常平键相连。轴径尺寸寸公差h6。通常平键体积依照MB1096-79通常平键形式体积?的明定。连接法兰止门依照MB1801-79的(h9)顾及。摆线减速机与相互设备电机采用齿轮相连时，两者轴心线的同轴度不许多于齿轮所允许的区域。
XNUMX. If you use a sprocket to run a diesel engine, if you loosen the toothed chain too much, the lines will cause destructive force when braking.When connecting the gears, wheels, sprocket and other couplings to the output shaft of the cycloid reducer, indirect hammering is not allowed. The screw hole at the shaft extension end should be used to screw in the screw, and the pressure plate should be used to press in.
And it should be noted that the cycloid reducer after installation must be tested and run after being used again.Under the condition of stable driving during inspection, the driving is gradually accessed again.